Unlock Healium's Aura using Neurofeedback
BEFORE PAIRING
Ensure your Brainlink is fully charged using the provided cord for at least 5 hours. The light may turn blue on a partial charge, but you cannot pair it.
EEG sensors are extremely sensitive. Be sure to use the charge cord provided, as this matches the specifications needed for Brainlink. Using an alternative charger may send too much power to the unit and permanently damage your brainlink.
To Get Connected:
1. Turn on the VR goggles.
2. Center the Brainlink on your forehead with the pod on the left side.
a. Press and hold the button on the brainlink until you hear two beeps.
b. Wait until you hear another set of beeps. (This indicates your brainwave activity is being read.)
3. Place the VR goggles on your head over your brainlink.
4. Navigate to the settings. Open the Bluetooth settings. Find Brainlink Lite and press Pair. (Click scan if you cannot find it.)
WARNING
Quest will show your Brainlink as "connected" for a few minutes, then move it to the disconnected but "previously paired" section.
Don't worry! The Brainlink should still be connected. Continue with these steps:
5. Close the settings.
6. Open the Healium App.
7. Login to the Healium App using your credentials.
8. Once you are in the Healium Lobby, at the bottom right-hand corner, click the far right triangule 
9. Confidently click the Connect button by the brainlink and wait 10 seconds.
a. A green checkmark indicates a successful pair. "Calculating baseline" will appear at the bottom of the screen.
b. If a red checkmark appears, try adjusting the Brainlink to ensure the sensors are on your forehead. (A red checkmark means the Brainlink is connected but unable to collect your brainwave activity.)
10. Once connected, click the X and start an experience. Enjoy!